DataCard CP60 Guide d'installation télécharger pdf (Page 74)

Page 69

DM-00767 Duplex Jam

The card is lost in the duplex module.

Possible Cause 1: A card is jammed in or near the duplex module.

Solution 1a: Open the of the printer (1). Release any cards stuck in the

module (2). Make sure that the duplex mechanism can move freely in the

direction shown (3).

Solution 1b: If the card is stuck between the upper and lower duplex units,

remove the card from the printer. You might see a “PR 01706” message

after removing the card. Clear the message to continue.

Possible Cause 2: The rollers in the duplex mechanism are dirty.

Solution 2: Run a printer cleaning card, and then clean the printer rollers

including the duplex module rollers.

If you cannot fix the problem, contact your service provider for assistance.

Pas de commentaire

DataCard CP60 Guide d'installation Page 74