DataCard CP60 Guide d'installation télécharger pdf (Page 62)

Page 57

Set the IP Address, Subnet Mask, and Gateway Address

Tips for Success

• The printer address mode must be “Static IP” to set these values. (If the address mode is DHCP, “IP

Addresses” does not appear in the menu.)

• The menu system moves from one value to the next because these values are related and a change in the IP

address usually leads to a change in the subnet mask (and sometimes in the gateway address).

• If you need to change just one value, you can scroll to the value you need to change in step 2 below.

1 With “Configuration” displayed on line 1, press the Up or Down Arrow key if needed

to display “IP Addresses” on line 2.

2 Press the Enter key to choose the “IP Addresses” list. “IP Address” is displayed on

line 2.

3 Press the Enter key. The printer shows the current IP address and a cursor

appears under the first byte of the address. (The address byte shows 3 digits when

it can be changed and the cursor appears under the right-most digit.)

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 133 134

Pas de commentaire

DataCard CP60 Guide d'installation Page 62