DataCard CP60 Guide d'installation télécharger pdf (Page 19)

Page 14

5 After it is printed, remove the card from the output hopper.

Tips for success

• Allow 30 to 60 seconds for the printer to begin printing the test card.

• The status light will flash green while the printer is processing the data.

• If the status light is steady amber and the printer beeps, the printer is paused. Press the Ready key once to

un-pause the printer.

• If the printer test card did not print successfully, try the procedure again, making sure you follow the

instructions. If the test card does not print, or if the printer does not initialize, contact your service provider.

• The test card has the pattern shown. (The pattern will be monochrome dots, not colored dots, if the printer

uses a monochrome ribbon.)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 133 134

Pas de commentaire

DataCard CP60 Guide d'installation Page 19