DataCard LM200 Guide de l'utilisateur télécharger pdf (Page 83)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 77

Printer LCD messages

LCD Message Possible Cause Solution

Please, Power Off The power must be turned

off to initialize the printer.

Turn the power switch off and then on again.

Please Remove Media

Cassette

Cleaning cannot start

when the retransfer film

cartridge is in the printer.

1 Remove the retransfer film cartridge.

2 Press Reset and then Return to initialize the

printer.

3 Start the cleaning cycle again.

HR is too hot Cleaning cannot start

because the temperature

of the heat roller is too

high.

1 Power off the printer and allow the heat roller to

cool for about 20 minutes.

2 Power on the printer and start cleaning again.

Make sure that the retransfer film cartridge has

been removed.

3 See

“Cleaning the card feed rollers and heat

roller” on page 63

for instructions on how to clean

the card feed and heat rollers.

4 Contact your service provider if “HR is too hot”

appears on the LCD panel and you are not cleaning

the printer.

Jam (Hopper) There is a card jam in the

hopper section.

1 Remove jammed card from the card hopper.

2 Press Reset, and then Return to initialize the

printer.

3 See

“Hopper jam” on page 72.

Jam (Turnover) There is a card jam in the

turnover section.

1 Remove jammed card from the turnover section.

2 Press Reset, and then Return to initialize the

printer.

3 See

“Turnover jam” on page 74.

Jam (MG) There is a card jam in the

magnetic stripe encode

section.

1 Press Reset, and then Return to initialize the

printer. If no card is discharged, remove the card

from the encode section.

2 Press Reset, and then Return to initialize the

printer.

Jam (Transfer) There is a card jam in the

card feed rollers.

1 Remove the jammed card.

2 Press Reset, and then Return to initialize the

printer.

3 See

“Transfer jam” on page 73.

Jam (Discharge) There is a card jam in the

card discharge section.

1 Press Reset, and then Return to initialize the

printer.

2 Remove the jammed card from the retransfer

section.

3 Check that the card stacker is securely attached to

the stacker receptacle. An incorrectly mounted card

stacker can cause discharge jams.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 108 109

Commentaires sur ces manuels

Pas de commentaire

DataCard LM200 Guide de l'utilisateur Page 83

Commentaires sur ces manuels