DataCard LM200 Guide de l'utilisateur télécharger pdf (Page 45)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 39

Printer Select tab

The Printer Select tab shows:

• The currently selected printer.

• The unit number. (Use the LCD panel to set

the unit number, described in “Using the

Printer LCD Panel” on page 51.)

• If more than one SR-CP printer is installed on

the PC, you can change the printer for which

information is displayed by choosing it from

the Current Printer list. The Status Monitor will

communicate with the printer to update

information.

• Use the Scan button to locate another printer

if it is not displayed in the list. The printer and

Status Monitor support IPV4 which is

commonly used, and IPV6 which is a newer standard that uses longer addresses.

The choice affects which printers are found when scanning. Only printers on the

same subnet as the PC can be found.

• Use the Sync Time button to send the current time on the PC to the printer.

• Use the Update button to send changed values to the printer.

• Use the Refresh button to obtain current values from the printer.

• If the printer is set to use a LAN connection this tab displays the default settings

(which cannot be changed). If the printer is connected using a USB connection, you

can use this page to set the IP address and other network values. See

About

Network Settings in the Installation Guide.

• If scanning does not find a printer, you can register it by entering the IP address.

Printers with IPSec enabled must be registered before information will be displayed.

• If you need to assign a printer name different from a choice provided by the printer,

make sure the printer is installed with a USB connection and then enter the new

printer name. The name can include only ASCII alphabetic or numeric characters,

(other characters are not displayed at the printer). Your network administrator can

provide information about allowed or required names on your network.

• Security settings, which can be set only when the printer is connected using a USB

connection, are available. Use the

Details button to open the IPSec Setting dialog

box. See the Installation Guide for the steps to follow.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 108 109

Pas de commentaire

DataCard LM200 Guide de l'utilisateur Page 45