DataCard LM200 Guide de l'utilisateur télécharger pdf (Page 42)

36 SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide

Bend Remedy tab

The printer is available with a bend remedy option. Single-sided printing can cause the

card to warp, depending on the type of cards you use.

If the option is installed, the tab shows:

• A matrix for setting the bend remedy time and

temperature. Click a square to choose the

setting. Click the Update button to send the

settings to the printer.

• The card type, set on the Media Setting tab.

Tips for success

• The Card Type is blank if the Bend Remedy

option is not installed in the printer.

• Bend remedy is effective for single side

printing. For double side printing, choose the

Disable button.

• When you change to Disable and the Bend

Remedy option is installed, the printer goes into

Preheat state for about 10 minutes

while the roller temperature drops. Wait until the printer state changes to

Ready.

• The side of the card where the bend remedy is performed can become faded.

• Make sample cards to verify settings before using the new settings.

Media Setting tab

The Media Setting tab shows:

• The type of Ink ribbon in the printer, the lot number of the ribbon, and the number of

panel sets included in the ribbon. The printer provides this information and it cannot

be changed. If the printer cannot recognize the type of ink ribbon, one of the

following reasons is displayed:

Display Reasons for ink recognition error and the solutions

252: Invalid TAG Data The data for the ink ribbon is incorrect. Replace the ink ribbon and try again.

253: Defective TAG The printer did not recognize the print ribbon data. Replace the ink ribbon and

try again.

254: No TAG The printer could not read the print ribbon data. Make sure the ink ribbon has

been loaded correctly. See

“Load ink ribbon” on page 10.

255: Defective R/W The printer is defective. The printer must be repaired.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 108 109

Pas de commentaire

DataCard LM200 Guide de l'utilisateur Page 42