DataCard UltraGrafix Select Manuel d'installation télécharger pdf (Page 175)

Maxsys and MX6000 Software Administrator’s Guide 163

Defining the Magnetic Stripe Properties

Define the magnetic stripe properties as detailed in the following table.

Track Location Y Origin The location (top or bottom) of the track

Track Location Y Position The distance of the track from the top of the card

Transition Height The width of the track

Bits Per Character The number of bits (not including the parity bit) of each

character

Maximum Encode Length The maximum number of characters allowed

Density The number of characters/bits per inch

Parity Character parity (even, odd, none)

LRC Longitudinal redundancy check (even, odd, none)

Encode Method F2F is currently the only supported encoding method

Write Level Percentage The strength of the write level based on the coercivity level

selected in the Card Setup

Start Position The sentinel starting position from the edge of the card

Start Sentinel Position The starting position (right, left) of the sentinel

Start Code The start character/code (used for track 3 only)

Start Sentinel The character/code in the data that causes the encoding

to commence

End Sentinel The character/code in the data that causes the encoding

to end

Encode By Position is the only supported option

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 321 322

Pas de commentaire

DataCard UltraGrafix Select Manuel d'installation Page 175