DataCard SP75 Plus Guide d'installation télécharger pdf (Page 94)

Page 89

OP-01612, OP-01662 Card Jam

A card is stuck in the laminator.

Possible Cause 1: A card is stuck in the laminator.

Solution 1a: Turn the Laminator Advance Knob to move the card (A). You

can turn the knob in both directions.

Solution 1b: If it is difficult to turn the Laminator Advance Knob or you hear

clicks when you turn it, remove the laminator cartridge (B). Pull firmly to

remove the cartridge. Turn the Laminator Advance Knob again (A) to move

the card.

Solution 1c: If the card will not move, power off the printer and allow it to

cool down. Pull the card out.

Tips for Success:

• If cards get stuck often, run a cleaning card, change the cleaning sleeve,

and then clean the rollers in the printer.

• If you are using topcoat in one or both laminators, run a laminator

cleaning card. See Production in SP Series Info Central for the steps to

follow.

• If you are running a laminator cleaning card, this message can appear

when you place the card under the white stripe in the output hopper.

Push the card in farther and start the laminator cleaning card again.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 135 136

Pas de commentaire

DataCard SP75 Plus Guide d'installation Page 94