DataCard ImageCard Select Guide de l'utilisateur Page 53
- Page / 154
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Maintaining the printer 4-9
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
6 Print a card to verify the quality of printing. You can print a printer test card, a
sample card, or a card using your card creation application.
♦
Cleaning tips
Follow these tips to clean your printer effectively and maintain optimum operation.
• Clean the ribbon tracker using the printer cleaning pen.
• Some card features can require more frequent cleaning of the printer, especially if
the cards are not high quality. Signature panels and magnetic stripes can deposit
particles on rollers. Use the prompted cleaning cycle more often than the default
of every 250 cards.
• Clean printer rollers regularly, such as daily or every 1000 cards. If your printer is
connected over a network using a print server, the cleaning frequency set in the
printer will apply to cards sent from all attached PCs.
• If you use StickICards, clean the card tracks after every 100 cards. Use the
cleaning pen to reach most areas of the card track. Use an isopropyl alcohol swab
(not included in the cleaning kit) to reach hidden areas of the card track.
Cleaning the printhead
The printhead can have contamination stuck to it. You might notice it as unprinted
lines on printed cards. Clean the printhead only when needed, such as:
• The printhead has been accidently touched, such as when changing supplies or
cleaning a card jam
• You have replaced the printhead
• Your observe problems with card appearance
Do not touch the printing edge of the printhead cartridge with your fingers. The oils
on your fingers can damage the printhead.
Do not bump the printing edge of the printhead cartridge with any sharp objects.
Sharp objects can permanently damage the printhead.
Use the cleaning pen to clean the printhead. Do not use a cotton swab. The fibers
from the cotton can stick to the printhead.
Clean the printhead
1 Power off the printer, and disconnect it from the power source.
2 Press down on the swing arm. The push latch will release the swing arm. Lift the
swing arm until it is fully open.
!
!
- User’s Guide for 1
- ImageCard® Select™ and 1
- UltraGrafix® Select™ 1
- Printers 1
- Regulatory compliance 2
- Trademark acknowledgments 2
- Proprietary Notice 2
- Contents 3
- Overview 7
- About this manual 8
- Audience 8
- About the Select printer 8
- Printer models 9
- 1-4 Overview 10
- Printer features 11
- 1-6 Overview 12
- 1-8 Overview 14
- • ECP parallel port 14
- • USB port 14
- Who to call for assistance 15
- 1-10 Overview 16
- Using the printer 17
- Loading cards 18
- Magnetic Stripe 19
- Smart Card Chip 19
- Loading the print ribbon 20
- Load the print ribbon 21
- Powering on the system 22
- Status light 23
- Making cards 24
- Print from a PC application 25
- Removing cards 26
- Responding to messages 27
- 2-12 Using the printer 28
- Fix a printer problem 28
- Shutting down the system 29
- 2-14 Using the printer 30
- Using the printer driver 31
- Tips for settings 32
- 3-4 Using the printer driver 34
- 3-6 Using the printer driver 36
- • Cleaning interval 36
- Use the Properties dialog box 37
- 3-8 Using the printer driver 38
- Using the Status Monitor 39
- Suspending the Status Monitor 41
- 3-12 Using the printer driver 42
- 3-14 Using the printer driver 44
- Maintaining the printer 45
- Running a cleaning cycle 46
- 4-4 Maintaining the printer 48
- Run a printer cleaning card 48
- Cleaning the printer rollers 50
- 4-8 Maintaining the printer 52
- Cleaning tips 53
- Cleaning the printhead 53
- 4-10 Maintaining the printer 54
- Power cable 56
- Ground cable 56
- 4-14 Maintaining the printer 58
- Troubleshooting 59
- Troubleshooting guide 60
- Make a printer test card 61
- 5-4 Troubleshooting 62
- Track Format Data 63
- 5-6 Troubleshooting 64
- Problems with card appearance 65
- Print Module 66
- 5-10 Troubleshooting 68
- 5-12 Troubleshooting 70
- Obtaining service 72
- When to obtain service 73
- Before you install 75
- Installation audience 76
- General requirements 76
- Selecting the site 77
- Environmental requirements 78
- Install the printer 81
- Unpacking the printer 82
- Connecting cables 83
- Connect a USB data cable 85
- Installing the printer driver 87
- 7-8 Install the printer 88
- 7-10 Install the printer 90
- 7-12 Install the printer 92
- Printing sample cards 95
- Setup tips 96
- Safety and compliance 99
- Liability statement 100
- Acknowledgments 101
- Supplies and cards 103
- Supply roll storage 104
- Card specifications 105
- Card size 105
- Card material 105
- StickICards 106
- New cards preferred 106
- Pre-punched cards 106
- Card quality guidelines 107
- Cleaning supplies 108
- Cleaning kits 109
- Magnetic stripe cleaning card 109
- Cleaning pen 109
- Printer driver CD-ROM 110
- Printer components 111
- Data cable 112
- Power cord 113
- Smart card serial cable 113
- Print ribbon cartridge 114
- Card cartridge 114
- Related publications 115
- PC settings 117
- Set up two ECP parallel ports 118
- • Setting USB port values 121
- Setting parallel port values 122
- Setting printer permissions 122
- Figure C-3: Ports dialog box 125
- Setting Value 125
- Magnetic stripe encoding 131
- NTT character set 132
- Magnetic Stripe Setup 133
- Installation messages 135
- Possible Cause Action 136
- Digital signature not found 144
- Numerics 147
Produits connexes et manuels pour Imprimantes d'étiquettes DataCard ImageCard Select
(25 pages)New Holland No manuales de usuario
La lista de productos de New Holland No contiene 24 manuales de usuario para 24 seleccionados. Todas las guías de usuario en pdf están disponibles para descargar o ver en línea.
Commentaires sur ces manuels