DataCard RL90 Guide de l'utilisateur télécharger pdf (Page 14)

Load Supplies

8 RP90 and RL90 User Guide

Load Supplies

Load cards

The card hopper can hold approximately 250, .030” (.75mm) cards. The cards

are loaded and held in position with a card bracket. Make sure that magnetic

stripe or smart cards are loaded in the proper orientation for processing.

1 Open the card hopper.

2 Slide the card bracket to the left until it latches.

3 Insert cards. See the diagrams below for the correct card orientation.

— Load magnetic stripe cards with the magnetic stripe down and

facing the card bracket.

— Load smart cards with the smart card chip toward the back of the

card hopper, facing the card feed roller.

4 Slide the card bracket back into position carefully so cards are not

disturbed and your fingers do not get pinched.

5 Close the card hopper.

Tips: Handling cards

•

Do not open the card

hopper when “Loading”

is displayed on the LCD

panel.

•

Do not touch the

surface of cards before

printing them. (Oils on

hands will reduce

printing quality.)

•

Handle cards by the

edges or wear cotton

gloves.

•

Cards can stick

together. Slide or fan

cards to separate the

edges.

•

Orient all cards the

same way.

•

Do not use cards that

are bent or otherwise

damaged.

•

See

“Supplies” on

page 55

for specific

card information.

Smart card chip orientation

Magnetic stripe card orientation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 74 75

Commentaires sur ces manuels

Pas de commentaire

DataCard RL90 Guide de l'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Multifonctionnels DataCard RL90