DataCard RP90 Plus Manuel d'installation télécharger pdf (Page 7)

4 Installing the Printer

1. On the back of the laminator, set the voltage switch above the power

receptacle according to your power requirements. (The factory default setting

is 220-240V AC.)

2. Mount the RP90 Plus E printer over the holes on the joining plate as shown in

the following figure.

3. Mount the RL90 laminator over the remaining two holes on the joining plate

as shown in the figure below.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Pas de commentaire

DataCard RP90 Plus Manuel d'installation Page 7