DataCard ImageCard Select Guide de l'utilisateur télécharger pdf (Page 20)

2-6

Getting started

User’s Guide for Express™ and Select™ Class Printers

The printer power supply automatically adjusts to the voltage of the input power.

♦

Loading cards

Load cards when beginning work or when the card cartridge is low on cards or empty.

You can load cards when the printer power is on or off. You can also load cards while

the printer is printing.

To order more cards, contact your card vendor. For information on card requirements,

see “Supplies and cards” on page B-1.

Load cards

1 Lift the card cartridge up and out of the card cartridge cavity.

Pull up on the lower, rounded edge of the card cartridge to release the card

cartridge.

2 Fan cards (see Figure 2-3). Do not touch the surface of the cards.

Figure 2-3: Fan cards

3 Place up to 100 blank cards into the card cartridge. Do not touch the surface of

the cards.

For magnetic stripe cards, the magnetic stripe faces down and is positioned

toward the front of the printer (see Figure 2-4). If your card design requires a

different orientation, position the magnetic stripe up and toward the front of the

printer.

For smart cards, position the card so the chip is up and toward the right side of the

printer.

If your cards are thicker or thinner than 0.030 inch (0.76 mm), the maximum

number of cards you can load varies.

74030c9

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 109 110

Pas de commentaire

DataCard ImageCard Select Guide de l'utilisateur Page 20